JWD1-4/2R Z-Y Screw Type Double Layer Resistive Type Din-Rail TB

Description

Type

Unidirectional conducting terminal:

Connect a rectifier diode between the conducting plates in the upper and lower layers, or between the conducting plates in the lower layer (see the schematic diagram).

JWD1-4/2R Z-Y

(1) End plate: (thickness: 2.5)

One additional piece must be attached to the end of each terminal strip set. If it is mounted in the center of the terminal strip, the creepage distance may increase.

2.5-4/2 G

(2) Compensating end plate: (thickness: 2.5)

It is used to offset interlayer displacement while it is adjacent to an ordinary terminal.

2.5-4/2 BD

(3) Compensating end plate: (thickness: 2.5)

It is used for terminal locating and fastening of the terminal strip or for offsetting interlayer displacement while it is arranged with other terminals in the same group.

2.5-4/2 BD-1

(4) Central liaison part:

It is used to connect terminals with the same specification and form a liaison terminal group; each part has 10 digits (supplied with screws) that can be further divided at will.

ZL6/10

(5) Connecting sheet:

For central connection of more than 10 digits

LJ6/2

(6) Edge liaison part:

Its role is the same as that of the central liaison part (4); with insulation on the back side; 10 digits that can be further divided at will

2 digits:

5 582 122

200

3 digits:

5 582 123

200

10 digits:

5 582 130

100

(7) Jumping liaison part:

With the spacer (6), it can connect any non-adjacent terminals in the center.

KL6/10

(8) Spacer:

Used as a spacer block between the accessory of the jumping liaison part (7) and the conductive part of the terminal

K6

(9) Divider:

It is used to separate two adjacent liaison terminal groups and can be inserted after assembly, without any effect on the overall space.

GP-1

(10) Group partition: (thickness: 2.5)

Used for separation of each terminal group; with dual effects (visible grouping and electrical isolation)

2.5-4/2 GF

(11) Tag:

ZP6