JWD1-2.5JD Screw Type General Din-Rail TB

Description

Type

Ground terminal:

The yellow-green insulating housings can be mounted on the mounting rails

JWD1-2.5 JD

Edge liaison part:

Its role is the same as that of the central liaison part (2); with insulation on the back side; 10 digits that can be further divided at will

2 digits:

BL5/2

3 digits:

BL5/3

10 digits:

BL5/10

Tag:

It can be quickly inserted in the upper grooves on both sides of the terminal as a whole for any identification. It has a total of 10 digits (to be divided at will); it is white.

ZP5

Terminal dimensions

Thickness / width

[mm]

5.2/42.5

Height (TH 35:7.5 / TH 35:15 / G 32:15)

[mm]

47/54.5/52

Technical data based on IEC/DIN VDE standards

Rated impulse withstand voltage / degree of pollution

[kV]/-

8/3’)

Over-voltage category / insulation material group

-/-

III/I

Connection capacity

Flexible conductor with tubular bare terminal / tubular pre-insulated terminal

[mm2]

0.25 -2.5/0.25-1.5

Connection of multiple conductors (two conductors with the same cross-sectional area)

Rigid conductor / flexible conductor

[mm2]

0.2 -1.5/0.2-1.5

Flexible conductor with tubular bare terminal

[mm2]

0.25-1.5

Flexible conductor with DEV-tubular pre-insulated terminal

[mm2]

0.5-1.5

Stripping length

[mm]

8

Screw for terminal position: screw type / torque

-/[Nm]

M 3 / 0.6-0.8

Central fastening screw: screw type / torque

-/[Nm]

M 2.5/0.5-0.6

Insulation material type

PA

Material flammability according to UL94

V0

Rated working voltage / rated working current / wire gauge

UL:[V]/[A]/AWG

-/-/28-12

Note: When an edge liaison part is used, a cable below 1.5 mm2 should be used for a 2.5 mm2 terminal; corresponding cables should be used for terminals with other cross-sectional areas (mm2).

1) If this terminal is adjacent to a feed-through terminal with the same configuration, and the voltage is greater than 690 V, one end plate must be inserted.