JWD1-16JD Screw Type General Din-Rail TB

Inquire Now

Share:

Product Description
Parameters
Certification

Terminal thickness: 12.2
	Rigid conductor	Flexible conductor
	(mm2)
IEC 60947-7-2	2.5-25	45398

Description		Type
Ground terminal: The yellow-green insulating housings can be mounted on the mounting rails and		JWD1-16 JD
Edge liaison part: Its role is the same as that of the central liaison part; with insulation on the back side; 10 digits that can be further divided at will	2 digits
	3 digits	BL 12/10
	10 digits
Edge liaison part: Its role is the same as that of the central liaison part; with insulation on the back side, inserted in the conductor holder, and clamped on the insulation housing of the terminal	2 digits
	3 digits
Prismatic conductor holder: A prismatic metal block used to compensate the pressed flat conductor
Terminal fastener: (thickness: 10) It is used to finally fix a large-current terminal; after it is pushed, it can be mounted on Type TH35/15 mounting rail, and it should be fixed with two screws.		ZG1
Tag: It can be quickly inserted in the upper grooves on both sides of the terminal as a whole for any identification. It has a total of 10 digits (to be divided at will); it is white.		ZP10

Terminal dimensions
Thickness / width	[mm]	12.2/42.5
Height (TH 35:7.5 / TH 35:15 / G 32:15)	[mm]	54/61.5/59
Technical data based on IEC/DIN VDE standards
Maximum rated working current / cross-sectional area	[A] / [mm2]	101/25
Rated impulse withstand voltage / degree of pollution	[kV]/-	8/31)
Over-voltage category / insulation material group	-/-	lll/l
Connection capacity
Flexible conductor with tubular bare terminal / tubular pre-insulated terminal	[mm2]	1.5 -16/1.5-16
Connection of multiple conductors (two conductors with the same cross-sectional area)
Rigid conductor / flexible conductor	[mm2]	1.5 -6/1.5-4
Flexible conductor with tubular bare terminal	[mm2]	1.5-6
Flexible conductor with DEV-tubular pre-insulated terminal	[mm2]	0.75-10
Stripping length	[mm]	11
Screw for terminal position: screw type / torque	-/[Nm]	M 4/1.5-1.8
Central fastening screw: screw type / torque	-/[Nm]	M 4/1.5-1.8
Insulation material type		PA
Material flammability according to UL94		V0
Rated working voltage / rated working current / wire gauge	UL: [V]/[A]/AWG	-/-/22-4

Note: When an edge liaison part is used, a cable below 1.5 mm2 should be used for a 2.5 mm2 terminal; corresponding cables should be used for terminals with other cross-sectional areas (mm2).

1) If this terminal is adjacent to a feed-through terminal with the same configuration, and the voltage is greater than 690 V, one end plate must be inserted.