JGD-12DC/24-48DC/50-100 photoelectric coupling TB

With the continuous improvement of the automation degree, the isolation between control and field circuits is increasingly important. As the core of an automatic control system, the control unit must be reliably isolated from various sensors and actuators to avoid interference. Our photocoupler module can well perform the function above and can also be used for peripheral equipment control during process control. It serves as interface element between signal and an adjusting device matching the connection and is applicable to different voltage and power ranges. As the photocoupler can offer the necessary secure interface and has the following features, it has a wide range of applications.

> Low signal loss on the control site

> High switching frequency

> Free of contact chatter

> No impact from vibration

> No impact from position

> Without mechanical components

> Long service life

> High isolation voltage

Thanks to the advantages above, the photocoupler is another coupled mode in addition to the electric coupler.

Part Number		5 574 351
Technical Data
Input	Input voltage	12VDC±20%
	Connected voltage	About 8.2V
	Input current	≤8mA
	Maximum input power	105mW
Output	Output voltage	24-48VDC
	Maximum output current	24DC/50mA 48DC/100mA
	Minimum output current	10uA
	Maximum motion frequency pulse ratio 1:2	300Hz
	Voltage drop under the maximum load	≤1V
	Pickup delay	20μS
	Return delay	200 μS
Insulation parameter
Rated voltage		300V
Rated impulse voltage		2.5KV
Over-voltage category		III
Degree of pollution		2
Clearance and creepage distance		≥3.2mm
Working temperature: without gap		-25°C~+40^oC
With gap		-25°C~+50°C
Storage temperature		-40°C~+85°C
Applicable conductor		AWG 24-14
Cross-sectional area of applicable conductor		0.5- 4 mm²
Overall dimensions
Thickness / width / height ()		6.2/66/60mm
End plate		G-JGD(JC) 910242

Tag 8868103		ZP6
Edge connecting part		BL6/2 BL6/3 BL6/10